Introduction to Metallization Technology of Zirconia Ceramic Structural Parts

Zirconia ceramic structural components can be metallized through some processes. Below, Kezhong Ceramic Factory will take you to learn about this technology.

The metal of zirconia ceramic structural components melts, and the cross-section begins to be filled in its F-form. After passing through the metal cross-section, it is fused into its F4FH weld seam, with a fusion ratio of 7. When its size affects soldering, its composition and mechanical properties of the product combination can be compared. The proportion of the entire metal weld seam is a part of the size. Therefore, when comparing the steel and chemical differences of the weld seam, the chemistry of the weld seam is affected by the material.

The fusion point represents the occupation of various proportions. After comparing the metal and chemical composition, if the two points have a significant difference, the influence of the base material composition and composition of the fusion will be greater. When non-standard zirconia ceramic structural components have more impurities than welding wires.

When the steel of large-diameter zirconia ceramic structural components contains more alloy elements, the welding wire contains less metal elements. Through the improvement of alloy elements and the ability of the weld seam, the comparison of fusion points and the mechanical properties of high incandescence joints are increased. After analysis, it can be seen that large-diameter materials with relatively low gold content and less gold elements play a key role in improving the lifting performance of welding seams when the controlled welding wire and metal material are filled with more elements.

The degree to which the chemical composition of the weld seam of zirconia ceramic structural components is directly affected by the steel composition is directly related to the fusion ratio. The greater the fusion ratio, the greater the influence of the crack composition of the base material, and the increase in the generated thermal cracks will have a tendency.

Website: https://www.zhengtaifeng.com/