The tensioner of automatic winding machine can be configured in several ways

The choice of a fully automatic winding machine tension depends mainly on what kind of product you are winding, and the requirements of the winding accuracy are not high; and most of the tensioner tensioner is used for coil production; in general, the tensioner's of the tensioner There are three ways: high, middle and low -grade.

1. High end

The wound machine servo tensioner is high -match. The working principle of this tensor is to convert the angle to the electrical pulse signal to the servo motor automatically through the angle shift sensor of the tension arm. When it is 1G, the output tension is particularly stable, almost no fluctuations, and it has its own tension and stability. It helps to be highly required for fine -line and winding accuracy. If you do not consider the cost, you can choose this winding machine tensioner.

2. Mid top

Electronic tensioner is a medium configuration. This uses friction -free electromagnetic technology. The tension caused by the mechanical factors of tension instruments has been reduced a lot. Most of the windows are used to choose this winding machine tensioner.

3. low match

The mechanical tensioner contains magnetic, mechanical friction tensioner, and magnetic damper. These tensors are pure mechanical. This kind of tensor itself is all based on mechanical spare parts to generate tension. It is the configuration of a general factory winding machine. It belongs to the popular tensioner. So be careful before choosing!

https://www.zhengtaifeng.com/en/raoxianji/502.html

For the current industry in the winding machine, it has a very bright prospect, because a lot of electronic products we use needed coils, as small as a headset, as large as car electronics. Less electronic components. With the continuous pursuit of excellent performance of the product and the requirements for the quality of each component are also continuously improved, the products processed by the processing components must not only meet the application standards, but also the beauty.

In the implementation of the winding function, we must first accurately calculate the number of circles that need to be winded at each layer. Different skeletons, the corresponding number of wounds are also different; secondly After restarting, continue to run on the basis of the original; after Z, ensure the aesthetics of the coil around and the flatness of the coil surface.