Do you know anything about the manufacturer of fully automatic winding machines?

The safety protection device system of the fully automatic winding machine manufacturer's winding machine is based on the JG series circular winding machine design. After on-site inspection and conversation with operators, it was found that when workers operate this series of circular winding machines, they put the unwrapped iron core into three rolling wheels. The specific operation is to open the dovetail lock strip of the storage ring body, separate the movable section of the storage ring opening, and allow the center of the additional winding iron core to pass through the opening part of the winding ring; Then lock the lock strip and press the foot switch to rotate the wire storage ring, with a high speed of up to 700r/min. During the process, it is necessary to manually pull the wire head from the winding iron core to the other side

Due to the high speed of the winding machine, workers from the fully automatic winding machine manufacturer need a fast speed to operate the bracelet. At this time, two types of finger injuries occur: the broken enamel wire will insert into the finger, causing finger injuries; The copper wire running at high speed can press on the fingers, causing minor skin injuries to the fingers or crushing the fingers in severe cases.

The requirement is that the safety protection device of the winding machine is that when the operator's hand enters a dangerous area, the infrared light emitted by the reflector is reflected into the receiver. The infrared sensor feeds back the low voltage signal to the logic chip, and then the logic control chip outputs the control signal to the relay deceleration module through microcontroller or logic judgment based on the position of the input signal.

The functional differences of the same type of automatic winding machine are also significant, and the processing quality of models with different configurations will vary greatly, and their pertinence is also different. Choosing configurations and functions that match their own process can reduce procurement costs. Due to the difference in the configuration of an attachment, it may cause problems in actual winding processing in the future, and it is not advisable to spend higher costs to correct them.

By serializing resistors with different resistance values into the foot pedal speed control circuit, the voltage ratio of the foot pedal device is changed, thereby reducing the frequency of the winding machine frequency converter, achieving the effect of reducing the speed of the winding motor, ensuring the safety of the operator. Improper operation of textile operators can cause injuries, effectively improving the safety of the winding machine.

Website: https://www.zhengtaifeng.com/