Transformer winding machine

Automatic winding machine is a commonly used model, and its structural form is divided into vertical type and column type. It is generally common that horizontal winding machine is a special equipment for winding transformer coils. The traditional transformer winding machine is relatively simple and all of them are artificial wire arranging and shaping models. Modern models have self-operated wire arranging series, and transformers are large electrical components, so the winding machine is relatively large in structure, and its weight ranges from several hundred kilograms to several thousand kilograms according to the level of winding machine. Due to the continuous application of modern technology in transformer winding machine, the new model has become more powerful in function. The appearance of flexible pre-compaction device replaces the traditional cumbersome process of manual tapping and shaping, which makes the winding process of transformer simpler. How to adjust the winding machine of transformer After setting the step sequence, press "Step Setting" and "Enter" to set the step sequence data, and then press "Enter" to enter the next parameter after setting the corresponding one. 1. Set the winding starting point, that is, set the starting position of winding. 2. The width is the width of the flat cable. 3. The wire diameter can be determined according to the width/number of turns, or it can be slightly reduced according to the actual wire diameter, so that the flat cable will be more compact. 4.

6. Low speed is a transformer winding machine that needs to be set up only after winding the idle train and stopping the idle train. The common functions are preset number of turns, automatic parking, forward and backward winding, automatic slot crossing, etc. In practical use, several points should be paid attention to. First, the slow train winding function is to run slowly after the equipment is started, in order to reduce the impact on the tension structure and enameled wire, and the general situation can be set to 1 to 3 turns according to actual needs. The idle stop function refers to the idle running of the equipment before the winding sequence is finished. This function can reduce the impact on the brake and make the equipment finish winding smoothly, especially for the winding process that needs precise positioning. This parameter must be set, and the parameter should be adjusted accordingly according to the different running speed of the equipment. Generally, it is 2 to 5 turns, followed by the direction of wire arrangement and winding. These two parameters are the setting of the displacement direction of wire arrangement and the rotation direction of the main shaft respectively. There is a specific linkage relationship between the winding shaft and the spindle of the self-propelled winding machine, which is controlled by the controller. When setting, it is necessary to find out the displacement direction of the winding shaft. Many users report the equipment alarm when debugging. This is because of the equipment protection caused by the wrong setting. The winding machine has a detection zero point for positioning the winding shaft. If the equipment is started from the zero point, the winding shaft must move outward. If it is mistakenly set to move inward, it will cause the equipment alarm. The rotation direction of the winding shaft should be determined according to the winding process.

Website: https://www.zhengtaifeng.com/