Method of adjusting servo tensioner and matters needing attention in use

The servo tensioner is to change the active line method by the traditional passive line delivery method. According to the user requirements, you can choose to divide the tensioner with two tension tensions. By replacing the tension range of the spring, you can use 1G-600g The system can automatically achieve the stability and balance of tension. The tension is not affected by factors such as winding speed, wire cover, pulleys, etc., tension is particularly stable, and the adjustment is simple and convenient.

The preparation of the servo tension before booting:

1. Balanced handle, the tension rotation is 0

2. Relax of wool rings, the degree of looseness of the wool ring is adjusted according to the size of the tension,

3. Relax of the tension of the lamb hair circle, the tension and the large wool ring are tight

The 607 control system will automatically adjust the correction volume according to the diameter of the recovery/put on the feed/put.

https://www.zhengtaifeng.com/en/WireTensioners/333.html

The method of adjusting the servo tensor and paying attention to the use:

1. The structural design is compact, small in size, and can work in order in various positions.

2. The installation structure is simple, the output torque adjustment profit stool. The damping disk does not contact the magnet and has no sliding friction. Therefore, the service life is long, and the tension control is simple operation.

3. Magnetic obstruction, also known as tension controller, tension or brake, is a device that conveys constant torque with magnetic fields as the medium.

4. The mechanical servo tensioner should not work too much during installation, which will affect the firmness of the inlaid parts.

5. To prevent the fall of the servo tensioner, it will damage the ceramic and the shell.

6. Tiring the screws when installing the tension rod should be aimed at the axial plane.

7. Do not use it barely if you do not match the model.

8. No oil is prohibited in the damping wheel.

9. Don't open your own adjustment without authorization.

10. Frequent replacement of wool rings to avoid blocking the line.

11. Please change it in time if there is an abnormal or not transferred in a wire, because the bearings have been worn.

12. If the damping wheel is rotated and slipped, please use the O -shaped circle in the damping wheel with a cotton line with alcohol, so as to remove the wax dirt remaining in the lacquer cable.

Finally, it is necessary to keep the production venue cleaning, and the long period of dust accumulation is easy to wear tensioner components.

https://www.zhengtaifeng.com/en/WireTensioners/327.html